ThingHz Wireless Sensor Network
Hardware and PCB design
linux for rescue
IoT Backend and SaaS platform
Embedded Firmware
ThingHz Wireless Sensor Network
ThingHz Sensor nodes
AWS Serverless application and web dashboard
ThingHz Android application
Hardware and PCB design
ThingHz Wireless gateway with CAT-M NB-IoT modem and LoRa
ThingHz Wireless Sensor Network Gateway top PCB layout
ThingHz Wireless Sensor Network Gateway bottom PCB layout
ThingHz Wireless Sensor Gateway acts as the creates a point to point mesh network with ThingHz wirelesss sensor. It gathers data from the sensors and sends to cloud using different modes of communication from wireless sensor to gateway and gateway to cloud . This gateway provides you following features:
- ThingHz Wireless sensor has LoRa capability can serve as Lora gateway for ThingHz wireless sensors
- In built WiFi and BLE.
- It uses Cat- M NB-IoT modem for cloud interactions
- it constitutes high end Battery Management system and can be powered by single Cell Li-Ion battery, solar and DC 12 V supply.
- GPIO Connectors, which gives us multiple digital and analog inputs and outputs
ThingHz Wireless Sensor with I2C extender
ThingHz Wireless sensor top PCB layout
ThingHz Wireless sensor bottom PCB layout
Features of ThingHz range of wireless Sensors:
- Comes with I2C extender to connect up to 256 sensors on same line
- 24/7 real time monitoring and analysis
- Two modes of operations works as a standalone as well part of integrated mesh network using ESPNow with ThingHz wireless gateway.
- Over 1.5 Km[1mile] LoS range.
- Small Form Factor (2.9 x 1.7 inch) and Light Weight (150 g)
- charge and signal indicator
- Battery management system with Over charge protection.
LoRa Gateway with Rock-Pi S and RAK LPWAN concentrator
LoRa Gateway top PCB layout
LoRa Gateway bottom PCB layout
LoRa gateway features
- includes highly efficient SBC RockPi -S
- Includes RAK833 LPWAN Concentrator
- Works with multiple spread factors and channel
- it is able to receive up to 8 LoRa packets simultaneously sent with different spreading factors on different channels.
Solar charger for Li-Po and Li-ion with battery protection
Solar Charger top PCB layout
Solar Charger bottom PCB layout
Solar Charger features
- single series Li-ion and Li-Po charger.
- Wide Input Voltage: 4.5V to 28V
- Fast charging with charge current up to 4A
- 5V Boost available
- Over charge and Over voltage protection
- constant voltage of 4.2 V
And Many More….
linux for rescue
Tab Content
IoT Backend and SaaS platform
Tab Content
Embedded Firmware
Tab Content